This tutorial outlines how to Install, Configure and Enable SNMP on a Turbonomic instance and Linux Virtual Machines. This is a document I wrote over at the Turbonomic Green Circle Community.
The instructions cover how to setup Linux-based VMs that are under Turbonomic’s control including those running in the Public Cloud. This process has been used when unable to use Public Cloud providers tools when gathering Memory metrics.
I am spinning up a few CentOS 7 Servers in preparation for a Kubernetes/OpenShift Lab I am planning on running
There are a few ways to add a Static IP to a CentOS box. Here I will use the Network Manager TUI.
I have a few SMB Shares running in my Home which i wanted to access from one of my Ubuntu Desktops. The Share in question was a Software repository on my NAS and so in my instructions you will see software or sw referenced, these you will have to change with your equivalent.
First thing to do is grab the cifs-utils
sudo apt-get install cifs-utils
I recently only had SSH Access into an Environment which had a Web Based GUI I needed to access. I used SOCKS as a Proxy (Built into OpenSSH) to access the UI by performing the following on my Mac:
As I had SSH Access i used the following command
Pre-reqs:
Instructions:
Run the following
Check to see if the following file exists: /etc/apt/sources.list.d/docker.list
For this example i will create a user account called newuser – this will need to be replaced by whatever you want your account to be called.
Create new user account: sudo adduser newuser
Enter and confirm a password and complete the Information if necessary:
Create a directory to mount the cdrom
sudo mkdir /mnt/cdrom
Now need to see where the cdrom is mapped to, so run:
lsblk
I recently ordered a Raspberry Pi 3 (currently £30.80) with an SanDisk Ultra 8 GB microSDHC Card (Currently £4.35) with the intention of installing Kali 2.0. For this setup i used my Windows 10 PC.
This post will cover setting up the SD Card and installing Kali
I downloaded the ARM Image from the Offensive Security Site, which comes down compressed. I also downloaded Win32 Disk Imager and installed it.
For this install I chose to use MySecureShell as a small and quick way to stand up an SFTP Server. As usual all commands are in Bold.
Log into your Ubuntu Server with Admin credentials:
Sudo apt-get install mysecureshell
cd /etc/apt (more…)
run ifconfig to find the name of your Interface. Normally these would be eth0, eth1 etc but in my Virtual Environment they are different
My Infrastructure Blog focused around Virtualisation, Storage, Server and other Tech
My Infrastructure Blog focused around Virtualisation, Storage, Server and other Tech
My Infrastructure Blog focused around Virtualisation, Storage, Server and other Tech
My Infrastructure Blog focused around Virtualisation, Storage, Server and other Tech
